Frequently Asked Question's
At Microplacer India, we produce PCB assembly panels with a minimum size of 50x50mm and a maximum size of 310x410mm. We can manufacture circuit boards based on your panelized PCB file. If you only have a single PCB file, our team can assist in panelizing the design according to your specific requirements before proceeding with manufacturing.
We require 0.0mm spacing between each unit for panel with V-cut. V-cut cannot be used for panels with units of different sizes.As the V-scoring could only go all through the whole board and no-stop, V-cut cannot be used for the panel with units of different size. Take the following panel for an example, we would recommend Tab-routing instead of V-cut.



For panel with Tab-route, we need 2.0mm spacing between each unit. We offer two options for tab-routing: Tab-Route with breaking holes and Tab-route with tabs.
• Tab-Route with breaking holes
For this kind of Tab-route, we require breaking holes diameter be between 0.3mm-1.0mm, spacing between the breaking holes be ≥0.25mm, breaking holes number in each tab be around 5-6. See the following picture for an example.

• Tab-Route with breaking holes
For this kind of Tab-route, we require breaking holes diameter be between 0.3mm-1.0mm, spacing between the breaking holes be ≥0.25mm, breaking holes number in each tab be around 5-6. See the following picture for an example.

• Tab-route with tabs, the width of tabs should be 1.0mm.

For panel with both V-cut and Route fiducial, we require 2.0mm spacing between each unit. Please refer the following image to design the panel.
Fiducial marks and mounting holes in panel


Fiducial marks and mounting holes in panel

1. Fiducial marks
For each panel, we require at least 3 fiducial marks. Those marks should be placed in the middle of the tooling strips with the diameter at 1.0mm. The fiducial marks on board's left should be 10.0mm away from the board edge, and the right ones should be 15.0mm away from the board's right edge. Following image is for your reference.
For each panel, we require at least 3 fiducial marks. Those marks should be placed in the middle of the tooling strips with the diameter at 1.0mm. The fiducial marks on board's left should be 10.0mm away from the board edge, and the right ones should be 15.0mm away from the board's right edge. Following image is for your reference.

2. Mounting holes
We would recommend diameter of mounting holes to be set at 3.0mm and the width of tooling strips at 7.0mm, and at least 5.0mm distance from the edge of the board. Check the image below for reference.
We would recommend diameter of mounting holes to be set at 3.0mm and the width of tooling strips at 7.0mm, and at least 5.0mm distance from the edge of the board. Check the image below for reference.

Need assistance with PCB assembly panelization?
Microplacer is your one-stop partner for PCB fabrication, component sourcing, PCB assembly and electronics manufacturing. Get an instant online price for your boards and assembly, or send us your files — our engineers check every order before production and keep you updated until delivery.
Streamline your innovation with
seamless PCB ordering.